Specification:

• Material: Aluminium Alloy

• Color: Silver

• Thread Diameter(approx.): 22mm/0.87''

• Input pressure: 0-10mpa

• Intake link: GB cylinder interface G5/8

• Outgassing link: M10*1 outer filament

• Output pressure: Fine tune out bubble seconds calculation

• Up to 1500 psi (lb/sq inch).

• Compact & sturdy construction.

• Single gauge pressure indicator.

• Compatible with various size of CO2 Cylinders.

• No wrench needed, handy installation. Convenient and simple.

Usage Introduction:

• Make sure that the cylinder is stationary and locked tightly.

• Please do not add any lubricant.

• Please do not disassemble the device.

• With the check counter bubble gauge, the reading is accurate, the built-in check reverse backflow can prevent the backflow phenomenon when the cylinder pressure decreases.

Adjustment Method:

• Step 1.Close CO2 gauge, install pressure reducing valve, connect equipment.

• Step 2.Open the relief valve trim switch, and adjust the gas output. Smaller than required.

• Step 3.Adjusting pressure reducing valve 8 hours later.

Package Included:

• 1 Pc * CO2 Pressure Gauge

• 1 Pc * Ring Washer

Note:

• Please note this m22-14 do not fit cylinder in USA and Canada.

• The thread is made according to UK, Europe, Japan and Taiwan standard (JIS m22-14), 22mm in diameter.

• Please allow minor deviation due to manual measurement.

• Due to the difference between different monitors, the picture may not reflect the actual color of the item.

Â

Take me out on Lazada	Take me out on Shopee